OBD Power Cable for Dash Camera,OBD2 to USB C Adapter Hardwire Kit with Low Voltage Protection(11.6V/23.4V),Dual Mode with 24/7 Parking Mode/ACC Mode,Constant Power Supply for Continuous Recording

Conoce más detalles

Smart Dual Modes with Selector Switch : Mode 【0】：ACC Mode, The type c dash cam hardwire kit auto powers cut off 20 minutes after engine shut-off（(in some cases 20-30 minutes or more) depending on the vehicle's OBD system logic）, preventing battery drain and achieving an ideal balance between convenience and vehicle safety. Mode 【-】：24/7 Parking Surveillance，When your car is off, the dash cam power cord provides continuous power, It cuts power 5 minutes after detecting a low battery voltage (11.6V for 12V or 23.4V for 24V vehicles), enabling 24/7 anti-theft monitoring while protecting your battery. Low Voltage Protection【11.6V/23.4V Auto-Cutoff】: This ACC hard wire kit prevents a dead battery by automatically cutting power at 11.6V (12V vehicles) or 23.4V (24V vehicles). This crucial feature prevents complete discharge while preserving sufficient charge for a smooth start—even after long-term parking. Stable 5V/3A Power Output : The hardwire kit for dash camera ends restarts and video lag, shields the mainboard from ignition surges, and records post-parking incidents (scratches, collisions) with a 5-minute delay-off, helping to ensure 24 hours evidence recording. 6-in-1 Circuit Protection System: ACC detection hardwire kit features six key safeguards—Low Voltage Cut-off,Anti-Drain Protection,Over-Current,Short-Circuit,Reverse Polarity and Overheat Protection—to reliably protect both your dash cam and vehicle's electronics." Direct OBD Power & Data Safety : The hardwire charger taps power directly from your OBD2 port, freeing up your 12V socket. It supports continuous recording with auto shut-off, all while drawing only power and ensuring total data isolation from your vehicle's ECU. Universal Compatibility : This 3.5-meter (11.5-ft) OBD extension 24-hour parking monitoring cable fits 12V/24V vehicles—including cars, SUVs, trucks and big rigs—and works with almost all Type-C dash cams.Designed for A5-B5 pin definition,NOT compatible with A8-B8 pins or 12V input. Play and Plug ,Easy Installation : Skip complex wiring. Just plug OBD power adapter into your OBD-II port—no tools, no drilling! Get your dash cam running in under 3 minutes for a clean, hidden wiring. Easy for beginners. Friendly Note : Some vehicles cut OBD-ii port power when turned off—this is the manufacturer’s design, not an issue with the OBD Charger cable. If it fails to power your device after startup, drive to 20 km/h (12 mph) to activate it (some models don’t supply power instantly).