Riyitauto Dash Camera OBD Hardwire Kit OBD Power Cable for Dash Camera USB Type C 12-36V to 5V/3A with Low Voltage Protection 24h Parking Surveillance/Acc Mode fit for Dashcam, GPS or Radar

Conoce más detalles

[Dash Cam OBD Hardwire Kit] Input:DC 11.6V-36V; output:DC 5V/3A; Length:3.5 m (11.5 ft); Dash cam obd power cable suitable for Car Type-C Plug And Miciro USB Plug Dash Cam tachograph DVR, GPS, dashboard camera, radar, mobile phone, such as Jeep Cherokee, Chevrolet, Toyota, truck and other models of the tachograph power cord (!!!!!!not fit to electric vehicles) [MODE 1 Mode"-"] 24 hour parking monitoring mode: When your car ACC is turned off, the OBD power cord will continue to work, and the power will be cut off when the voltage drops below 11.6V [MODE 2 Mode "O"] ACC mode, which only provides power when the engine is on, and then when your ACC mode is off in this mode, the OBD hardwire cable will automatically power off after 20 minutes after the engine is off [Low Voltage Protection] OBD Power Cable for Dash Camera Provides intelligent low voltage detection and protection functions that automatically cut off the power output when the battery voltage is below 11.6V, which can prevent your car battery from running out and ensure that you have enough voltage to start the car the next time you drive [Easy Installation] OBD Power Adapter Installation is very convenient,only from the OBD interface to obtain power, do not interfere with other OBD data communication, just plug it into the car's OBD connector, ensure that the dashcam power supply, and then wire along the trim strip and roof lining, hide the excess wire, cable long enough to maintain the interior clean appearance, USB C USB plug 90° tilt "L" design: ideal for space-saving and tight space connections [Warm reminder] OBD2 Power Cable OBD power cable for dash camera type c suitable for Car Type-C Plug And Miciro USB Plug Dash Cam most products on the market, not fit to electric vehicles. When Switching Between Mode 1 And Mode 2.The OBD adapter must be unplugged and reinserted Once, Otherwise the Mode switching Will Not Working