AC1200M Dual Band WIFI Network Repeater, 5G/2.4G Wireless Signal Amplifier

Conoce más detalles

If your router with WPS button, you can plug the WIFI amplifier, first press the router's WPS button, and then press the WIFI amplifier's WPS button, wait for 2 minutes to connect! If you can't search the amplifier name and number, you can reset it, plug the amplifier into the power supply, use the configured pin to insert the small hole at the bottom of the amplifier for 10 seconds, wait for the indicator to change to complete the restoration of factory settings and then search for the name and number, or press and hold the amplifier WPS button for 10 seconds and release it for a few seconds to complete the restoration of factory settings and then search for the name and number after the indicator has changed. Relay Mode: Sometimes a device may be in the living room, but because of poor signal, the signal in the bedroom may be only one frame, which requires further expansion of the wireless network. At this time, you can consider using another wireless router to expand the network through the relay mode, "amplify" the name of the wireless signal and the original wireless router signal name is the same, such as cell phones, tablets, and so on, do not need to manually switch to rely entirely on the network to cover themselves. Characteristics: You need to connect to another WiFi signal when setting up relay, and keep the WiFi name setting exactly the same. Scenario: expand the network to realize a certain range of signal "roaming". AP mode: AP mode is special, generally AP hotspot devices only have this function, and AP devices do not have bridge, routing mode, but support the relay function. The difference between relay and AP hotspot is also very simple, relay mode is actually 1:1 to extend a wireless network, and does not require cable connection, and both the router and AP devices support this mode; AP mode is to use the network cable to expand WiFi signals, but it is not responsible for its own management of the network, the equivalent of a switch with wireless capabilities, the wired signal is converted to wireless only, other functions need to rely on the router to expand the WiFi signal. Other functions need to rely on the router to realize (assign IP, manage the network, etc.). Characteristics: through the network cable into a wireless network, no management, routing function. Applicable scenarios: cover the dead end of the signal, the function is similar to the relay, but the AP device does not need to be configured, plug and play.