









Artículo: AMZ-B0BGLLN8WG
Go Kart Clutch 3/4 Bore 10T with #40/41/420 Chain, for Predator 212 Centrifugal Clutch Fit for Minibike MB165 & MB200 and Honda Cloned Engines GC160, GC190, GX120, GX140, GX160, GX200. Up to 2-6.5HP
Size:
3/4" Bore 10T with Chain
1" Bore 14T
1" Bore 14T with Chain
3/4" Bore 10T
3/4" Bore 10T with Chain
3/4" Bore 12T
3/4" Bore 12T with Chain
5/8" Bore 11T
En stock
1.99 kg
No
Nuevo
Amazon
- 【Suit for】: 3/4" bore Sprocket with 10T Suit for Go Kart Minibike Mini bike MB165 and MB200, also fit for Mini Baja, Baja Heat and the Baja warrior. (Note the fixed a pitch of #40#41#420 chain is 12.7 mm(0.5 inch))
- 【Compatible with】: This Clutch kit is compatible with 212cc Predator, 2-6.5hp Honda cloned engines GC160, GC190, GX120, GX140, GX160 and GX200. Also fit for Tecumseh and Briggs Stratton engines 6.5HP with 3/4" bar shaft and 3/16" Key Way.
- 【Tips】: Mounts onto crankshaft using bolt and washer on the end of the crankshaft. Before installation, you need to drop a circle of lubricant above the snap ring and wait for it to penetrate, you can rotate it without any obstruction (please refer to the picture for the exact position).
- 【Pre-use test】 When the clutch is just installed and started to run, it needs 3-5 times to break in. The method is as follows, first, no load running to the clutch first engagement, keep it for 10 seconds and then turn off the engine to cool down; second, load gradual 3 times from 0 to full speed, each interval of 2 minutes to cool down. If there is no problem after these two steps, you can avoid the problem that insufficient speed will cause the clutch internal dumping block and clutch shoe, and insufficient contact area will lead to slipping and friction smoke.
- 【Package including】:1 x Centrifugal Clutch, 1 x #420 Chain(96 links),1 x Connecting Link.
- 【Note】: Centrifugal clutch designed to be used on one wheel karts with rear tires ≤ 15" tall, and engines 2hp-6.5hp.
IMPORT EASILY
By purchasing this product you can deduct VAT with your RUT number