DTXMX Flysky FS-i6 6 Channels 2.4G RC Transmitter and Receiver FS-iA6B Radio Controller for Helicopter Quadcopter FPV Drone (Mode_2)

Conoce más detalles

The transmitter and receiver were pre-bound before delivery. If you are using a different transmitter or receiver, follow the steps below to connect to the receiver's B/VCC port. 1, Connect the included binding cable to the receiver's B/VCC port. 2, Plug the DC 4V-6.5V power supply into other ports, the positive and negative poles cannot be wrongly connected. 3, Keep pressing the "BIND KEY", and then turn on the transmitter to enter the binding mode. 4, The transmitter will display the RX voltage, that means the binding is successful. 5, Remove binding wire, Check the operation of the servos. If something doesn't work as expected, start this process from the beginning. FS-i6 Specifications: *Pushing the left throttle stick up and down does not automatically return to center Channels: 6 CH Model Type: Multirotor/Fixed Wing/Heli [Parameters can be set to support quadcopters, although there is no quadcopter icon in the TX menu.] RF Range: 2.40-2.48GHz Mark width: 500KHz RF Power: Less than 20dBm 2.4GHz system: AFHDS 2A and AFHDS Code type: GFSK Sensitivity: 1024 Low voltage warning: less than 4.2V DSC connector: PS2; Output: PPM Charging Port: No Transmitter weight: 392g Transmitter size: 174x89x190mm Packing size: 23.5 x 21.2 x 10.6cm Package Weight: 676g Power: 6V, 4 x AA battery (not included) Display mode: STN transflective positive type, 128 x 64 dot matrix VA73 x 39mm, white backlight. Online update: yes Certification: CE, FCC Model Memories: 20 Control range: 500m【It depends on the usage environment, weather and other factors】 FS-iA6B Specifications: Channels: 6CH RF range: 2.408 - 2.475 GHz Band:135 RF Power: ≤20dBm RX Sensitivity: -105dBm 2.4G system: AFHDS 2A Code type: GFSK ANT length: 26mm * 2 (dual antenna) Input power: 4.0-6.5V DC Dimension: 43x26x15mm Weight: 16g i-bus interface: Yes Data Acquisition Interface: Yes Model Type: Multirotor/Fixed Wing/Heli Compatible Transmitters: Compatible with FS-i6, FS-I6X, FS-I6S, FS-i4 Contents of delivery: 1 x FS-i6 Transmitter 1 x FS-iA6B receiver 1 x Binding Cable 1 x Manual【EN & CN】 Support PWM/PPM/i.bus, How to turn on PPM: Press and hold the "OK" button on the right side of the screen for 2 seconds to enter the remote control menu-System-RX Setup-PPM Ostput setting to turn it on or off. Press and hold the "CANCEL" key on the right side of the screen for 2 seconds to save. Then the position of FS-IA6B receiver CH1 outputs PPM.