Artículo: AMZ-B0F541NXR8

Ransanx

Ransanx 4PCS IR Break Beam Sensor 5MM LEDs Counting Module Split Through-Beam Photoelectric Switch for Apply Relay, K60, PLC, 51 microcontroller, STM32 etc,Cable Length 30cm,Test Distance 1M

Size:

4PCS

1pcs

2PCS

4PCS

Style:

4PCS

1pcs

2PCS

4PCS

Detalles del producto
Disponibilidad
En stock
Peso con empaque
0.20 kg
Devolución
Condición
Nuevo
Producto de
Amazon
Viaja desde
USA

Sobre este producto
  • 4PCS IR Break Beam Sensor 5MM LEDs Counting Module Split Through-Beam Photoelectric Switch for apply Relay, K60, PLC, 51 microcontroller, STM32 etc
$60,27
60% OFF
$24,11

IMPORT EASILY

By purchasing this product you can deduct VAT with your RUT number

$60,27
60% OFF
$24,11

3 meses de gracia en diferidos y hasta 6 meses sin intereses con Pacificard

Envío gratis
Llega en 5 a 12 días hábiles
Con envío
Tienes garantia de entrega
Este producto viaja de USA a tus manos en

Conoce más detalles

【IR Break Beam Sensor】is the abbreviation of photoelectric proximity switch, which uses the beam of light of the detected object Occlusion or reflection is controlled by a synchronous circuit to detect the presence or absence of objects. Objects are not limited to metals,All reflective objects can be detected, with high sensitivity, fast response speed and good stability Faster than PIR sensors for better control of where you want to detect motion 【Sensor parameters】Detection distance: 1M, sensing mode: light speed interruption (infrared), working voltage: DC5V, working current: emission (20mA) reception (10mA), output current: 70mA (can directly drive the relay), emission angle: < 5 °, receiving angle: < 10 °, working temperature: -10 ° C~ 60 ° C, working environment: indoor (not waterproof),Working life: 50,000 hours,The terminal spacing is 2.54; the corresponding adapter connector needs to be equipped with a male plug of xh2.54 【Output mode】NPN normally open, response time: 2ms 【Note】That is, the red wire is connected to the positive electrode, the black wire is grounded, and the yellow (white) wire is connected to the signal. Add 1K pull-up resistor between the positive electrode and the signal to directly connect to the microcontroller I0 port 【After-sales service and applicable models】if you have any questions about the product, please contact us, we are 24 hours online, we will be the first time for you to solve the problem, looking forward to your visit, suitable for relays, K60, PLC, 51 microcontroller, STM32, for arduino and so on