Artículo: AMZ-B00LW15D1M

Hiletgo

HiLetgo 12V 1 Channel Relay Module with Optocoupler Isolation Support High or Low Level Trigger

Size:

Small

Disponibilidad
En stock
Peso con empaque
0.20 kg
Devolución
Condición
Nuevo
Producto de
Amazon

Sobre este producto
  • Module uses genuine high quality relay, normally open interface maximum load: AC 250V / 10A, DC 30V / 10A
  • Using optocoupler chip isolation, strong drive capability, stable performance; trigger current 5mA
  • Module can be set by jumper high or low trigger
  • Fault-tolerant design, even if the control line is broken, the relay will not move
  • The interface design of human nature, all interfaces are available through a direct connection terminal leads, very convenient
$12,47
31% OFF
$8,60

IMPORT EASILY

By purchasing this product you can deduct VAT with your RUT number

$12,47
31% OFF
$8,60

Compra más de $100 y te regalamos la mitad de la tasa arancelaria

$20 OFF al pagar con Deuna

Envío gratis
Llega en 5 a 12 días hábiles
Con envío
Tienes garantia de entrega
Este producto viaja de USA a tus manos en
Medios de pago Tarjetas de Débito, Crédito y Deuna

Compra protegida

Disfruta de una experiencia de compra segura y confiable

Conoce más detalles

Module description:Module Size: 50mm * 26mm * 18.5mm (L * W * H)With four fixed bolt holes, holes 3.1mm, spacing 44.5mm * 20.5mmPower Indicator (green), Relay Status Indicator (red)Interface: Input: VCC: Relay power supply + GND: Relay power supply - IN: Signal trigger input (High or Low Level Signal, select via jumper) Output:NO: Relay normally open.COM: Relay Common Pin NC: Relay normally closed.Package Included:1*12V 1 Channel Relay Module With Optocoupler IsolationHow to provide an auto shut-down for Prusa i3 Mk2S? 1. Wired it in parallel with the power switch. 2. Use the hotend fan power as the trigger. 3. When you run a long print ,start the printer and when the hotend fan turns on (at about 50C) you can turn off the power switch. 4.The printer continues to run until the print is finished and the hotend cools below 50C. At that point the relay is no longer powered and the printer shuts itself off.

Ofertas del día
Ver más